Silencing An Audible Alarm - Eaton 5125 User Manual

TROUBLESHOOTING
Table 9. Troubleshooting Guide
Alarm or Condition

The indicator is not on;
the UPS does not start.

The indicator is flashing;
power is not available at the UPS
output receptacles.
The UPS operates normally, but
some or all of the protected
equipment is not on.
The UPS does not provide the
expected backup time.
54
Eaton 5125 Tower UPS (1000–2200 VA) User's Guide

Silencing an Audible Alarm

Before silencing an alarm, check the alarm condition and perform the
applicable action to resolve the condition (see Table 9).
To silence the alarm for an existing fault, press the
status changes, the alarm beeps, overriding the previous alarm silencing.
The alarm does not silence if there is a low battery condition.
Possible Cause
The UPS internal battery is not
connected.
The power cord is not connected
correctly.
The wall outlet is faulty.
The UPS is in Standby mode.
The equipment is not connected
to the UPS correctly.
One of the load segments has
been turned off through the
power management software.
The batteries need charging or
service.
Action
See "Connecting the UPS Internal Battery" on
page 20.
Check the power cord connections.
Have a qualified electrician test and repair
the outlet.
|
Press the On
connected equipment.
Verify that the equipment is plugged into the
UPS receptacles.
For hardwired models, contact a qualified
electrician to check connections to the power
source.
Reactivate the segment with the software.
Plug the UPS into a power outlet for 24 hours
to charge the battery. Press and hold the
button for 3 seconds.
If the indicator is still on, see "Replacing
Batteries" on page 42.
S 05147304 Rev C www.eaton.com/powerquality
button. If UPS
button to supply power to the