Eaton 5125 User Manual page 29

4. Plug the equipment to be protected into the appropriate UPS output
receptacles (see page 39 for more information on load segments).
NOTE DO NOT protect laser printers with the UPS because of the exceptionally high power
requirements of the heating elements.
5. For 208V/230V models only. Plug the detachable UPS power cord
into the input connector on the UPS rear panel.
6. Plug the UPS power cord into a power outlet.
The front panel indicators cycle through a startup sequence while
the UPS conducts a self‐test. When the self-test is complete, the

the equipment offline. If the alarm beeps or a UPS alarm indicator
stays on, see Table 9 on page 54.
7. Press and hold the On button until you hear the UPS beep
(approximately one second).
The
display the percentage of load being applied to the UPS. The UPS is
now in Normal mode and supplying power to your equipment.
NOTE The batteries charge to 90% capacity in approximately 3 hours. However, it is
recommended that the batteries charge for 24 hours after installation or long-term storage.
NOTE If more than two EBMs are installed, an external battery charger is recommended
for faster recharge times.
Eaton 5125 Tower UPS (1000–2200 VA) User's Guide
indicator flashes, indicating the UPS is in Standby mode with

indicator illuminates solid and the bar graph indicators
S 05147304 Rev C www.eaton.com/powerquality
INSTALLATION
23