Table 8-1 Terminal On Network And Line Settings - Lantronix I/O 2100 User Manual

Terminal on
Network and Line
Settings
Terminal Type
Login Connect Menu
Exit Connect Menu
Send Break
Break Duration
Echo
IntelliBox-I/O 2100 User Guide

Table 8-1 Terminal on Network and Line Settings

Description
Enter the Terminal Type to be sent from the host via IAC.
Note: IAC means "interpret as command". It is a way to send
commands over the networks such as send break or start
echoing.
Select the interface to display when the user logs in. Choices are:
Enabled = shows the Login Connect menu
Disabled = shows the CLI (default)
Select whether to display a choice for the user to exit the Login
Connect menu and reach the CLI. Choices are:
Enabled = a choice allows the user to exit to the CLI
Disabled = there is no exit to the CLI (default)
Enter a Send Break control character, e.g., <control> Y, or keep
blank to disable. When the Send Break control character is
received from the network on its way to a Serial Line, it will not be
sent to the Line; instead, the line output will be forced inactive.
Note: This configuration option is only available for Line
Terminals.
Specify, in milliseconds, how long the "spacing"condition will be
placed on the line when a break is sent. May enter a value up to
10000. Default is 500.
Note: This configuration option is only available for Line
Terminals.
Select whether to enable echo. Choices are:
Enabled
Disabled
Note: Applies only to Connect Mode Telnet connections, not to
Accept Mode. Only disable Echo if your terminal echoes, in which
case you will see double of each character typed. Default is
enabled.
8: Terminal and Host Settings
77