Front Panel Connectors - DFI WB72-SC User Manual

Rev. a+ system board

Hide thumbs Also See for WB72-SC:

Table of Contents

Hardware Installation

2.7.19 Front Panel Connectors

HD-LED: Primary/Secondary IDE LED

This LED will light when the hard drive is being accessed.

G-LED: Green LED

This LED will not light when the system's power is on or when the

system is in the S3 (STR - Suspend To RAM) state. It will blink every

second when the system is in the S1 (POS - Power On Suspend)

state.

ATX-SW: ATX Power Switch

Depending on the setting in the BIOS setup, this switch is a "dual

function power button" that will allow your system to enter the Soft-

Off or Suspend mode. Refer to "Soft-Off By PWR-BTTN" in the

Power Management Setup (Chapter 3).

G-SW: Green Switch

This switch will allow your system to enter the Suspend mode.

RESET: Reset Switch

This switch allows you to reboot without having to power off the

system thus prolonging the life of the power supply or system.

SPEAKER: Speaker Connector

This connects to the speaker installed in the system chassis.

Table of Contents