Table of Contents
Advertisement
AC97 Modem
Auto
Select this option when using a primary or secondary
modem riser card, or audio/modem riser card.
Disabled Select this option when using a PCI modem card.
Onboard AC97 Codec
Enabled This option is used to enable the onboard AC97
codec.
Disabled This option is used to disable the onboard AC97
codec. Disable the onboard AC97 codec when using a
6-channel audio CNR card or an audio PCI card.
IDE HDD Block Mode
Enabled The IDE HDD uses the block mode. The system BIOS
will check the hard disk drive for the maximum block
size the system can transfer. The block size will depend
on the type of hard disk drive.
Disabled The IDE HDD uses the standard mode.
KBC Input Clock
This is used to select the input clock of your keyboard. The options
are: 8MHz and 12MHz. The default is 12MHz.
Keyboard/Mouse Power On
This field allows you to use the keyboard or PS/2 mouse to power-
on the system. To use this function, make sure JP1 is set to 2-3 On -
the Wake-On-Keyboard/Mouse function enabled. Refer to "Jumper
Settings for Wake-On-Keyboard/Wake-On-Mouse" in chapter 2 for
more information.
Disabled
Default setting.
Award BIOS Setup Utility
Warning:
If JP1 was previously enabled with a pass-
word set in the "KB Power On Password" field,
and now you wish to disable the keyboard
password function, make sure to set this field
to disabled prior to setting JP1 to disabled
(1-2 On). You will not be able to boot up the
system if you fail to do so.
3
6 7
Advertisement
Table of Contents
