Table of Contents
Advertisement
UART2 Mode Select
The system board supports IrDA function for wireless connectivity
between your computer and peripheral devices. You may not use
IrDA (J1) and the COM 2 serial port (CN5) at the same time. If
you are using the COM 2 serial port, make sure this field is set to
Normal.
To use the IrDA function, follow the steps below.
1 . Connect your IrDA cable to connector J1 on the system
board.
2 . Set the "UART2 Mode Select" field to the type of IrDA
standard supported by your IrDA peripheral/device (IrDA or
ASKIR). For better transmission of data, your IrDA peripheral
device must be within a 30
meter.
3 . Set the "RxD, TxD Active" and "IR Transmission Delay" fields
appropriately.
RxD, TxD Active
The options are Hi, Lo; Lo, Hi; Lo, Lo; and Hi, Hi.
IR Transmission Delay
If this field is Enabled, transmission of data will be slower. This is
recommended when you encounter transmission problem with your
device. The options are: Enabled and Disabled.
Onboard Parallel Port
378/IRQ7, 3BC/IRQ7, 278/IRQ5
IRQ for the onboard parallel port.
Disabled
Disables the onboard parallel port.
Parallel Port Mode
The options are SPP, EPP, ECP, ECP+EPP and PntMode. These apply
to a standard specification and will depend on the type and speed
of your device. Refer to your peripheral's manual for the best option.
Award BIOS Setup Utility
angle and within a distance of 1
o
Selects the I/O address and
3
6 9
Advertisement
Table of Contents
