Table of Contents
Advertisement
Wake-On-Keyboard/Wake-On-Mouse
This function allows you to use the keyboard or PS/2
mouse to power-on the system. Refer to "Jumper
Settings for Wake-On-Keyboard/Wake-On-Mouse" in
chapter 2 and "Keyboard/Mouse Power On" in the
Integrated Peripherals section in chapter 3 for more
information.
Important:
• The power button will not function once a
keyboard password has been set in the "KB
Power On Password" field of the Integrated
Peripherals submenu. You must type the
correct password to power-on the system. If
you forgot the password, power-off the system
and remove the battery. Wait for a few seconds
and install it back before powering-on the
system.
• The 5VSB power source of your power supply
must support 720mA.
Wake-On-USB Keyboard
The Wake-On-USB Keyboard function allows you to use
a USB keyboard to wake up a system that is in the S3
(STR - Suspend To RAM) state. Refer to "Jumper Settings
for Wake-On-USB Keyboard" in chapter 2 and "USB KB
Wake-Up From S3" in the Power Management Setup
section in chapter 3 for more information.
Important:
• If you are using the Wake-On-USB Keyboard
function for 2 USB ports, the 5VSB power
source of your power supply must support
1.5A.
• If you are using the Wake-On-USB Keyboard
function for 4 USB ports, the 5VSB power
source of your power supply must support
2A.
Introduction
11
1
Advertisement
Table of Contents
