Device Settings; Network - Lindy aJ-Orion User Manual

5.5 Device Settings

5.5.1 Network

The Network Settings panel allows network related parameters to be changed. Each parameter
will be explained below. Once applied the new network settings will immediately come into
effect.
Note: The initial IP configuration is usually done directly at the host system using the
special procedure described in Section 3, page 7.
Changing the network settings of the IP ACCESS KVM SWITCH CLASSIC might result in
losing connection to it. In case you change the settings remotely make sure that all the
values are correct and you still have an option to access the IP ACCESS KVM SWITCH
IP auto configuration
With this option you can control if the IP KVM SWITCH CLASSIC USB should obtain its network
settings from a DHCP or BOOTP server. For DHCP, select dhcp, and for BOOTP select bootp.
If you choose none then IP auto configuration is disabled.
IP address
IP address in the usual dot notation.
Subnet Mask
The net mask of the local network.
Gateway IP address
In case the IP KVM SWITCH CLASSIC USB is accessible from networks other than the local
one, this IP address must be set to the local network router's IP address.
36