Device Description; Security Advice; Content Of Delivery; Description - Lindy IPower Switch 4 DIN S Pro User Manual

Device Description

1 Device Description
1.1

Security Advice

· The device must be installed only by qualified personnel according to the following
installation and operating instructions.
· The manufacturer does not accept responsibility in case of improper use of the
device and particularly any use of equipment that may cause personal injury or ma-
terial damage.
· The device contains no user-maintainable parts. All maintenance has to be per-
formed by factory trained service personnel.
· Connect the device to the mains (230V AC) or to an AC Adaptor (10V to 24V AC,
12V to 28V DC, at 4 watts of power). Under no circumstances should the unit be fed
with the mains and the AC Adaptor at the same time!
· The device is intended for indoor use only. Do NOT install them in an area where ex-
cessive moisture or heat is present.
· Because of safety and approval issues it is not allowed to modify the device without
our permission.
· The device is NOT a toy. It has to be used or stored out or range of children.
· Care about packaging material. Plastics has to be stored out of range of children.
Please recycle the packaging materials.
· In case of further questions, about installation, operation or usage of the device,
which are not clear after reading the manual, please do not hesitate to ask our sup-
port team.
1.2

Content of Delivery

The package includes:
· IPower Switch 4 DIN S Pro
· Lindy QIG
1.3

Description

The IPower Switch 4 DIN S Pro can switch 4 different relay outputs and monitor 8
pass- ive signal inputs. The device has the following features:
· 4 switchable, potential-free relay ouputs, switching voltage 230 V AC 16 A / 24 V DC,
10 A
· Relays dispose of high contact reliability also at very small loads
· 8 passive inputs for monitoring NO and NC devices, e.g. door contacts, smoke de-
tectors etc.
· Stop input to switch-off of all relais
· Status and Power-up delay (0...9999 seconds) adjustable individually for each relay
port after power blackout
· Programmable turn-on/turn-off sequence
· 4-channel watchdog, an individual watchdog (ICMP/TCP) can be assigned for each
relay output
· Operation with 230 V AC or 24 V DC voltage
4