Device Settings - Lindy 39414 User Manual

Noise filter
This option defines how the KVM OVER IP SWITCH reacts to small changes in the video input
signal. A large filter setting needs less network traffic and leads to a faster video display, but
small changes in some display regions may not be recognized immediately. A small filter
displays all changes instantly but may lead to a constant amount of network traffic even if the
display content is not really changing (depending on the quality of the video input signal). All in
all the default setting should be suitable for most situations.
5.4.4 VNC
Video Settings
To use a VNC viewer to access the KVM over IP Switch the VNC server as to be enabled.
Please make sure youtr firewall does not block the relevant ports.
We have tested Tight VNC that works without any problems.
Most common VNC viewers can be used, however, some may use special settings. If you want
to use Real VNC please set it to video mode 3.
33

5.5 Device Settings

5.5.1 Network
The Network Settings panel allows network related parameters to be changed. Each parameter
will be explained below. Once applied the new network settings will immediately come into
effect.
Note: The initial IP configuration is usually done directly at the host system using the
special procedure described in Section 3.
Changing the network settings of the IP ACCESS KVM SWITCH CLASSIC might result in
losing connection. In case you change the settings remotely make sure that all the values are
correct and you still have an option to access the KVM over IP SWITCH.
34