Replacing The Lamp - High End Systems DL.1 User Manual

Replacing the Lamp

Warning: Equipment surfaces may reach temperatures up to 130° C (266° F).
Do not attempt to hot-restrike the lamp. Allow the fixture to cool
before handling or restriking the lamp.
To replace the lamp:
1. Lock the fixture head in place using the 90
as discussed in Figure 2-9 on page 2-12.
2. Unlatch and remove the rear bezel assembly.
3. Consult the projector manual (shipped with the DL.1 fixture) for lamp
replacement instructions.
4. Carefully replace the rear bezel, making sure to place (but do not force) the
gasket (shown in Figure 5-6 on page 5-8) over the lamp cover located on the back
of the projector.
5. Relatch the rear bezel assembly.
5-4 General Maintenance and Troubleshooting
°
pan lock and the 0
°
tilt lock settings
DL.1 User Manual