Menu Map - High End Systems DL.1 User Manual

Menu Map

Use the following table to navigate the menu options on the DL.1 fixture.
Level 1 Level 2
enters /exits Menu System and moves up
levels moves between items on same
level. selects
DMX ADDRESS
SET DMX START
CHANNEL:###
MENU
FACTORY DEFAULT
SETTINGS:###
PAN/TILT SWAP:
PAN INVERT:
TILT INVERT:
DISPLAY LEVEL:
DATA LOSS TIMEOUT:
PROJECTOR IN/SOURCE
PROJCTR DEFAULT?
RESET PROJ HRS
SET
PARAMETERS PROJ LAMP ON?
MENU XXX XXXXXXXXX
PROJ IN BY DMX?
IRIS VERSION
#### V1.0
ZOOM OVERRIDE MENU
VALUE:###
FOCUS OVERRIDE MENU
VALUE
###
PROJECTOR CONTROL ?
TO EXIT -> MENU
CAMERA OPTION
ALIGN PAN MOTORS
XXXXXX
NEW AIR FILTER?
XXX
FIXTURE MODE CROSSLOAD
MENU FIRMWARE
3-4 Fixture Operation
Level 3 Option/Setting
scrolls between values
selects
1-512
ON
OFF
ENABLED
DISABLED
ENABLED
DISABLED
ENABLED
DISABLED
ON
OFF
LONG
SHORT
RGBHV
SVIDEO
NOT AVAILABLE
YES
NO
YES
NO
ON-TAKES 90 SEC Select ON and Lamp will strike after a
OFF
ENABLED
DISABLED
PRE 1.0
POST 1.0
0-255
0-255
Select to hand off control to Projector. Navigation buttons now
control projector menu system. Use the MENU button used to
exit this option.
ENABLED
DISABLED
YES
NO/ABORT
YES
NO
NO
YES
Description/Notes
Selected value becomes the first DMX value
in the range for that mirror head on a DMX
512 link.
Reverts to DL.1 default settings
Indicates a factory default has changed
Swaps the Pan and Tilt Motion
Restores default Pan and Tilt Motion
Inverts Pan motor direction
Restores default Pan motor direction
Inverts Tilt motor direction
Restores default Tilt motor direction
Turns display on
Display fully dimmed when menu is locked
Shutter closes when fixture shuts down
Shutter closes one second after data loss
Selects RGBHV or VGA
Selects S-Video
Displayed when PROJ IN BY DMX is enabled
Returns the projector to its factory default
settings.
Leaves the projector's settings as they are.
Press <Enter> for 5 seconds to reset
projector hours
90-second delay.
Set projector input using channel 11 of the
DMX protocol.
Set projector input using the menu system.
Identifies fixture iris version
Manually sets DMX zoom value
Manually sets DMX focus value
Camera System installed and using 20-
channel DMX protocol.
Disables Camera System and reverts to 12-
channel reduced DMX protocol.
Aligns motors (30 minutes to complete)
Aborts align motors
Selecting YES after new air filter installation
calibrates the fixture.
Safe setting
Uploads fixture software to all other DL-1
fixtures on the link
DL.1 User Manual