Chapter 2: Setup And Configuration; Unpacking The Fixture; Replacing The Power Cord Cap - High End Systems DL.1 User Manual

Chapter 2:
Setup and Configuration

Unpacking the Fixture

Your DL.1 fixture ships in a road case that is specifically designed to protect the
product during transport. Unpack the DL.1 fixture and verify that it is undamaged.
Inspect both the outside of the fixture and the projector for physical damage to
components.
Your DL.1 fixture ships with the following:
• One road case
• One DL.1 fixture
• Two mounting brackets
• One projector manual
• One power cord
High End Systems® assumes no responsibility for products that are damaged during
transport. Return a product for repair in its road case.
Before sending anything to the factory, call your High End Systems dealer/distributor
for a Return Material Authorization (RMA) number. The factory cannot accept any
goods shipped without an RMA number.

Replacing the Power Cord Cap

The SEOW cable shipped with the DL.1 fixture does not have an attached power cord
cap. Different locations (even within the same country) may require a different
power cord cap to connect the fixture to a power outlet.
Because of the variety of power cord caps used worldwide, High End Systems, Inc.
cannot make specific recommendations for the power cord cap.
Contact a local authority for the type of power cord cap needed. When installing the
power cord cap, note that the cores in the mains lead are colored in accordance with
the following code:
• green and yellow = earth
• blue = neutral
• brown = live
DL.1 User Manual Setup and Configuration
2
2-1