Display Level; Data Loss Timeout; Projector Input Source - High End Systems DL.1 User Manual

4. Use the up and down arrows on the Navigation button to scroll to ENABLED to
invert Tilt movement or DISABLED to revert fixture to default setting and press
the Enter button to select.

Display Level

Use this menu option to turn the display on or off.
To change display level:
1. Press the Menu button to unlock the menu system or to move back up the system
to the top level menus.
2. Using the left and right arrows on the Navigation button, scroll through the top
level to SET PARAMETERS MENU and press the Enter button to select.
3. Using the left and right arrows on the Navigation button, scroll to the DISPLAY
LEVEL.
4. Using the up and down arrows on the Navigation button, choose ON to turn the
display on or OFF to dim the display and press the Enter button to store the
option.

Data Loss Timeout

Use this menu option to set the length of time required to close the shutter after DMX
data loss.
To change data loss timeout:
1. Press the Menu button to unlock the menu system or to move back up the system
to the top level menus.
2. Using the left and right arrows on the Navigation button, scroll through the top
level to SET PARAMETERS MENU and press the Enter button to select.
3. Using the left and right arrows on the Navigation button, scroll to DATA LOSS
TIMEOUT.
4. Using the up and down arrows on the Navigation button, choose LONG to set the
fixture to close the shutter only when the fixture shuts down or SHORT to close
the shutter about one second after DMX data loss.

Projector Input Source

Use this menu option to select either the RGBHV or S-Video inputs. The RGBHV
setting also enables you to accept VGA input.
Note: If the PROJ IN BY DMX? is enabled, the fixture is receiving DMX input
from a controller and the display for this menu will read NOT AVAILABLE.
See "Projector In By DMX?" on page 3-10 to disable this menu option
before setting Project Input Source .
3-8 Fixture Operation DL.1 User Manual