Advertisement
Quick Links
Before You Begin
Please note the following warnings and cautions before performing the procedure outlined in this
Installation Instruction.
Warnings: Disconnect power before servicing.
Equipment surfaces may reach temperatures up to 130° C (266° F). Allow the fixture to
cool before handling.
Open the Fixture
1. Lock fixture head in horizontal position.
2. Disengage the two latches (A) on the bezel and remove the back cover.
3. Remove the front bezel cover by turning two 1/4 turn latches (B).
4. Remove both side covers (C) by turning two 1/4 turn latches.
A
A
Install the Camera Module
1. Slide the camera module's
cable connector (D) straight
out and lift to install the
ribbon cable that shipped with
your kit. Insert ribbon cable
with the blue side up and
close connector.
2. Connect Camera Cable (E)
(p/n 90409161) to the camera
module below the ribbon
cable.
Installation Instruction
Subject: DL.1 Digital Eye Technology
Product Line: DL.1
B
D
60600239 Version 2.1
Camera Installation
Date: 11/20/04
C
E
page 1
Advertisement
Related Manuals for High End Systems DL.1 Series
Summary of Contents for High End Systems DL.1 Series
- Page 1 Installation Instruction Subject: DL.1 Digital Eye Technology Camera Installation Product Line: DL.1 Date: 11/20/04 Before You Begin Please note the following warnings and cautions before performing the procedure outlined in this Installation Instruction. Warnings: Disconnect power before servicing. Equipment surfaces may reach temperatures up to 130° C (266° F). Allow the fixture to cool before handling.
- Page 2 3. Mount Camera to bracket using 1/4-20 phillips screw (F). Insert 10-32 phillips pan-centering screw (G). 4. Mount the camera module to the Fixture using four M4 socket cap screws (H). Remove lens cap and discard. Lens Cap Connect the Module cables to the Camera Interface Board 1.
- Page 3 Install the IR Illuminator Board Before you begin, orient the front cover so that, when the IR board is installed and the cover is replaced on the fixture, the fixture’s front lable will be upright. 1. The kit ships with two different brackets for mounting the IR Illuminator board.
- Page 4 4. Reattach front bezel to fixture. 5. Reattach covers. If you experience any complications or have any questions regarding these installations, contact the High End Systems Service Hotline at 1.800.890.8989 to speak with a technician. 60600239 Version 2.1 page 4...