Compensating For Equaliser Curves (Eq-Ex); Setting The Sound Focus Equaliser (Sfeq) - Pioneer ANH-P10MP Operation Manual

Audio Adjustments
Only when the subwoofer controller setting is
"FULL Preout :FULL", you can switch to the non-
fading output on/off setting. (Refer to Setting the
rear output and subwoofer controller on page 94.)
You can select the nonfading output setting
("NoFAD2") only when nonfading output is
turned on in the nonfading output on/off setting.
When selecting the FM tuner as the source,
you cannot switch to "SLA".
1 Press AUDIO to display the audio func-
tion names.
2 To return to the display of each source,
press BAND/ESC.
Note
If you do not operate the audio function within
about 30 seconds, the display is automatically re-
turned to the source display.
Compensating for equaliser
curves (EQ-EX)
The EQ-EX function smoothes the effects of
each equaliser curve. Furthermore, you can
adjust bass and treble for each source when
CUSTM curve is selected.
1 Press AUDIO and then press NEXT.
2 Press EQ-EX to select the EQ-EX on/off
mode.
3 Press EQ-EX to turn EQ-EX on.
"EQ-EX ON" appears in the display. EQ-EX is
now on.
To turn EQ-EX off, press EQ-EX again.
Setting the sound focus equal-
iser (SFEQ)
Clarifying the sound image of vocals and in-
struments allows the simple staging of a natu-
ral, pleasant sound environment. Even greater
listening enjoyment will be obtained if seating
positions are chosen carefully.
FRT1 boosts the treble on the front output and
the bass on the rear output. FRT2 boosts the
treble and the bass on the front output and
the bass on the rear output. (The bass boost is
the same for both front and rear.) For both
FRT1 and FRT2, H setting provides a more
pronounced effect than L setting.
1 Press AUDIO and then press NEXT.
2 Press SFEQ.
3 Press the corresponding button to se-
lect the desired setting.
Display
OFF
FRT1-H
FRT1-L
FRT2-H
FRT2-L
CUSTM
4 Press or to select the desired posi-
tion.
Press or until the desired position ap-
pears in the display.
LEFT (left)—CENTER (centre)—RIGHT (right)
Notes
• If you adjust the bass or treble, CUSTM mem-
orises an SFEQ setting in which the bass and
treble are adjusted for personal preference.
Setting
Off
Front 1-high
Front 1-low
Front 2-high
Front 2-low
Custom
En
Section
11
85