Adjusting Bass And Treble; Using Bass Adjustment; Using Treble Adjustment; Using Loudness Adjustment - Pioneer ANH-P10MP Operation Manual

Audio Adjustments
Setting the rear output and subwoofer controller
on page 94.
3 Press or to adjust left/right speak-
er balance.
Each press of or
speaker balance towards the left or the right.
"BALANCE L09" – "BALANCE R09" is dis-
played as the left/right speaker balance moves
from left to right.

Adjusting bass and treble

Use this function to adjust the bass and tre-
ble. The ability to select the frequency as well
as the level gives you good control over the
tonal balance of the audio.
• If EQ-EX function has been selected and
only when EQ-EX is turned on and
"CUSTM" is selected as the equaliser
curve, you can adjust bass and treble set-
tings.
• If SFEQ has been set to "FRT1", bass ad-
justment affects only the rear output: front
output cannot be adjusted.
• If SFEQ has been set to "FRT1" or "FRT2",
treble adjustment affects only the front out-
put: rear output cannot be adjusted.

Using bass adjustment

You can adjust the frequency and the bass lev-
el.
1 Press AUDIO and then press BASS to
select the bass adjustment mode.
2 Select the desired frequency with
.
Press or until the desired frequency ap-
pears in the display.
40—63—100—160 (Hz)
moves the left/right
or
3 Press or to adjust the bass level.
Each press of or
the bass level. "+6" – "–6" is displayed as the
level is increased or decreased.
Note
The level adjustment is valid only for the frequen-
cy selected in step 2.

Using treble adjustment

You can adjust the frequency and the treble
level.
1 Press AUDIO and then press TREBLE to
select the treble adjustment mode.
2 Select the desired frequency with
.
Press or until the desired frequency
appears in the display.
2.5k—4k—6.3k—10k (Hz)
3 Press or to adjust the treble level.
Each press of or
the treble level. "+6" – "–6" is displayed as the
level is increased or decreased.
Note
The level adjustment is valid only for the frequen-
cy selected in step 2.

Using loudness adjustment

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press AUDIO and then press LOUD to
select the loudness mode.
Loudness level (e.g., "MID") appears in the
display.
increases or decreases
increases or decreases
En
Section
11
or
87