Navigation; Safety Instructions; Navigation Safety Instructions; Digitised Area - Pioneer ANH-P10MP Operation Manual

Section
02

Navigation

Safety instructions

• The requirements of the Road Traffic Regu-
lations (RTR) apply.
• Observation of traffic signs and local traffic
regulations always takes priority.
• Traffic guidance is restricted to passenger
vehicles. Special driving recommendations
and regulations for other vehicles (e.g.
commercial vehicles) are not taken into ac-
count.
• The destination must only be entered when
the vehicle is stationary.

Digitised area

• Some navigation CDs are supplied with
this product. These CDs contain a digitised
street map. Motorways, federal and region-
al roads, as well as district roads are de-
tailed in this street map. Larger cities and
boroughs are completely covered. The re-
gional and unclassified roads or access
roads and the town centre for smaller
towns and boroughs are included.
• One way streets, pedestrian zones, turn
bans and other traffic regulations are tak-
en into account as far as possible. There
may be discrepancies between the data on
navigation CDs and the actual local situa-
tion, due to permanent changes to road
systems and their traffic regulations.
• If you specify a location that does not exist
on the navigation CD in the CD loading
slot, a message appears on the screen
prompting you to replace it with another
navigation CD. After inserting the relevant
navigation CD, enter the road and, if re-
quired, the house number or the town cen-
tre. The required map data is loaded and
stored internally after route calculation has
started.
20
En
Basic operation for
navigation
This section describes how to use the Naviga-
tion System. More advanced navigation opera-
tion is explained starting on next page.
If you operate the navigation for the first time,
refer to Using navigation on page 16 for the
basic operation.
Displaying the Navigation
screen
1 Set the Navigation CD.
For setting the navigation CD, refer to Using
navigation on page 16.
2 When the Audio screen is shown, press
NAVI/OK to enter the Navigation mode.
The main navigation menu appears after a
while. For the following operation, refer to
Main navigation menu on page 21.
Notes
• Map data is on navigation CDs. The naviga-
tion CD for the destination country must be
loaded when starting navigation operation for
the first time.
• Pressing BACK quits the current menu and
displays the previous menu.
• This product can be switched to Audio by
pressing SOURCE.