Deleting A Stopover; Storing A Specified Destination In The Destination Memory; Storing In The Destination Memory - Pioneer ANH-P10MP Operation Manual

Navigation
4 To start route calculation to the stop-
over, select "START" and then press NAVI/
OK.
The route is calculated and route guidance
begins.
Notes
• is displayed inversely during route
guidance to a stopover.
• When you reach the stopover, the message
"YOU HAVE REACHED YOUR STOPOVER" is
displayed, and route guidance to the final
destination automatically starts.

Deleting a stopover

1 Press .
A confirmation message appears asking you
whether to delete the stopover.
2 To delete the stopover, press NAVI/OK
within 8 seconds.
The route is recalculated and route guidance
begins.
To continue route guidance with a stopover,
press BACK.
Storing a specified
destination in the
destination memory
Destination memory saves repeated manual
entry, if the destination is required at a later
date. Refer to Selecting a destination from the
memory on page 26.
Storing in the destination
memory
1 Specifying the location you want to
store by performing the same operation
as for the destination
Refer to Entering the destination information
on page 23.
The route menu appears when you enter the
location information.
2 In the route menu, select "SAVE DESTI-
NATION" and press NAVI/OK.
3 If necessary, input the place-name.
Refer to Entering texts on page 21.
Any name of your choice consisting of up to
20 characters can be entered for the specified
destination.
If you do not wish to enter a name of your
choice, press and hold NAVI/OK for more than 2
seconds.
Section
02
39
En