Avoiding A Traffic Jam; Entering The Length Of The Bypass; Delete Bypass; Stopover - Pioneer ANH-P10MP Operation Manual

Section
02 Navigation
Avoiding a traffic jam
This function allows you to block the ap-
proaching route sections as from the next
junction and calculate a bypass route when a
traffic jam or road block is directly ahead.
Entering the length of the
bypass
1 Press
2 Select the length of the traffic jam and
then press NAVI/OK.
(inversely) is displayed and the route is
recalculated.

Delete bypass

1 Press
2 To delete a bypass, press NAVI/OK
within 8 seconds.
The route is recalculated and route guidance
begins.
To continue route guidance with a bypass,
press BACK.
38
En
.
.

Stopover

This function enables a stopover to be entered
when route guidance is active.

Entering a stopover

1 Press .
2 Select the way to enter a stopover.
"LAST DESTINATIONS" and "DEST. MEMO-
RY" appears only when information is stored.
LAST DESTINATIONS: specifies the location
you have visited as a stopover. Refer to Selecting
a destination from the memory on page 26.
DESTINATION: enter the stopover informa-
tion from the start. Refer to Entering the destina-
tion information on page 23.
P.O.I.: specifies a special destination as a
stopover. Refer to Selecting a special destination
as destination on page 25.
DEST. MEMORY: specifies the location
stored in the destination memory as a stopover.
Refer to Selecting a destination from the memory
on page 26.
3 Specifying the location you want to
register as a stopover by performing the
same operation as for the destination.
Refer to Entering the destination information
on page 23.