Switching The Guidance Display For Intersection; Setting The Rear Output And Subwoofer Controller - Pioneer ANH-P10MP Operation Manual

Section
12 Initial Settings
Switching the guidance
display for intersection
The display can be magnified around an inter-
section to facilitate navigation (only when the
source is turned off).
1 With the source turned off, press and
hold 1.
2 Press NEXT and then press N.INT to se-
lect the intersection display mode.
3 Press N.INT to turn the enlarged dis-
play off.
"OFF" appears on the display.
Press N.INT again to turn the enlarged dis-
play on.
Setting the rear output
and subwoofer controller
This product's rear output (rear speaker leads
output and RCA rear output) can be used for
full-range speaker (FULL Preout :FULL) or
subwoofer (SUB.W) connection. If you switch
the rear output setting to "SUB.W", you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, the unit is set for rear full-range
speaker connection (FULL Preout :FULL).
When rear output is connected to full range
speakers (when "FULL Preout :FULL" is se-
lected), you can connect the RCA subwoofer
output to a subwoofer. In this case, you can
select whether to use the subwoofer control-
ler's (low pass filter, phase) built-in FULL Pre-
out :SUB.W or the auxiliary FULL Preout
:FULL.
1 With the source turned off, press and
hold 1.
94
En
2 Press NEXT and then press REAR to se-
lect the rear output setting mode.
3 Press SW or FULL to select the desired
output setting.
Pressing SW or FULL will switch between
"FULL" (full-range speaker) and "SUB.W"
(subwoofer), and that status will be displayed.
When no subwoofer is connected to the rear
speaker lead output, select "FULL Preout :FULL".
When a subwoofer is connected to the rear
speaker lead output, select "SUB.W".
When the rear output setting is "SUB.W", you
cannot change the subwoofer controller (Step 4).
4 Press or to switch the subwoofer
output or nonfading output (full-range
RCA output).
Pressing or will switch between
"FULL Preout :SUB.W" and "FULL Preout
:FULL" and that status will be displayed.
When adjusting the subwoofer sound by us-
ing an external amplifier, set to "FULL Preout
:FULL".
When adjusting the subwoofer sound by us-
ing this product, set to "FULL Preout :SUB.W".
Notes
• Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to Using nonfading output on page 88)
or subwoofer output (refer to Using subwoofer
output on page 88) in the audio menu on.
• If you change the subwoofer controller, sub-
woofer output and nonfading output in the
audio menu return to the factory settings.