Audio Adjustments; Using The Equaliser; Audio Adjustments Using The Equaliser; Recalling Equaliser Curves - Pioneer ANH-P10MP Operation Manual

Section
11

Audio Adjustments

Using the equaliser

The equaliser lets you adjust the equalisation
to match vehicle interior acoustic characteris-
tics as desired.

Recalling equaliser curves

There are six stored equaliser curves which
you can easily recall at any time.
1 Press EEQ to switch to the easy equal-
iser mode.
2 Press the corresponding button to se-
lect the desired equaliser curve
Here is a list of the equaliser curves:
Display
FLAT
S.BASS
PWRFL
NATRL
VOCAL
CUSTM
• CUSTM is an adjusted equaliser curve that
you create.
• A separate CUSTM curve can be created
for each source. (The built-in CD player
and the multi-CD player are set to the
same equaliser adjustment setting auto-
matically.) If you make adjustments, the
equaliser curve settings will be memorised
in "CUSTM".
• When "FLAT" is selected no supplement or
correction is made to the sound. This is
useful to check the effect of the equaliser
curves by switching alternatively between
"FLAT" and a set equaliser curve.
84
En
Equaliser curve
Flat
Super bass
Powerful
Natural
Vocal
Custom
Note
You can also use and
equaliser curve.
Introduction of audio
adjustments

Audio menu

The audio menu has the following functions:
F/B (balance adjustment)
EQ (equaliser curve adjustment)
BASS (bass level adjustment)
TREBLE (treble level adjustment)
LOUD (loudness)
ASL (automatic sound leveliser)
SW 1 (subwoofer on/off setting) or NoFAD1
(nonfading output on/off setting)
SW 2 (subwoofer setting) or NoFAD2 (non-
fading output setting)
HPF (high pass filter)
SLA (source level adjustment)
EQ-EX
SFEQ (sound focus equaliser setting)
If EQ-EX function has been selected and only
when EQ-EX is turned on and "CUSTM" is select-
ed as the equaliser curve, you can switch to
"BASS" and "TREBLE".
Only when the subwoofer controller setting is
"FULL Preout :FULL", you cannot switch to "SW
1". (Refer to Setting the rear output and subwoof-
er controller on page 94.)
You can select "SW 2" only when subwoofer
output is turned on in the "SW 1".
to select the desired