Initial Settings; Adjusting Initial Settings; Initial Settings Menu Operation; Using The Reverse Mode - Pioneer ANH-P10MP Operation Manual

Initial Settings

Adjusting initial settings

The initial settings menu has the following
functions:
REV (reverse demo)
F.DEMO (feature demo)
AUX (auxiliary input)
G.ANI (guide animation)
MUTE.S (mute setting)
M.LAN (multi language setting)
FM step (FM tuning step)
G.MIX (guide mixing)
N.INT (navigation intercept)
REAR (rear output and subwoofer controller)
D.ILM (illumination colour)
A.PI (auto PL seek)
TEL1 (hands free telephoning)
TEL2 (telephone standby)
SCROLL (ever-scroll)
Use the following instructions to operate each
particular setting.

Initial settings menu operation

You can operate the initial settings menu only
when the source is off.
1 Press and hold SOURCE to turn the
source off.
2 Press and hold
settings menu.
When the source is off, you can check the lo-
1" by turning on the feature demo.
cation of "
1 to enter the initial
Note
Press BAND/ESC to cancel the initial settings
mode.

Using the reverse mode

If you do not carry out an operation within
about 30 seconds, screen indications will start
to reverse, and then continue reversing every
10 seconds.
You can turn the reverse mode on or off.
1 With the source turned off, press and
hold 1 to select the reverse mode.
2 Press REV to turn the reverse mode on.
"ON" appears in the display.
Press REV again to turn the reverse mode off.
Section
12
91
En