Others Set Mode - Icom IC-R9500 Instruction Manual

11
SET MODE

■ Others set mode

Calibration Marker
This item is used for a simple frequency check of the
receiver. (default: OFF)
See p. 12-5 for calibration procedure.
NOTE: Turn the calibration marker OFF after
checking the frequency of the receiver.
Beep (Confirmation)
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration. (default: ON)
The beep output level can be set in level set mode.
(p. 11-6)
Beep Sound
Sets the desired key-touch beep sound frequency
from 500 to 2000 Hz in 10 Hz steps. (default:
1000 Hz)
[PANEL LOCK] SWITCH
Selects the Panel lock function activity from "ALL" and
"KEY." (default: ALL)
SPEECH Language
Selects the speech language from English and Japan-
ese. (default: English)
SPEECH Speed
Selects the speech speed from HIGH (faster) and
LOW (slower). (default: HIGH)
SPEECH S-Level
The IC-R9500 speech processor has frequency,
mode and signal level announcement. Signal level an-
nouncement can be deactivated if desired.
(default: ON)
When "OFF" is selected, the signal level is not an-
nounced.
OFF
ON
1000Hz
ALL
English
High
ON
11-10