D Programming The Select Memory Scan Setting - Icom IC-R9500 Instruction Manual

8
SCANS
D D Programming the select memory scan setting
• Memory-select window
D D Erasing the select scan setting
q Push [EXIT/SET] several times to close a multifunc-
tion screen, if necessary.
w Push [F-4•MEMORY] to select memory list screen.
e While pushing and holding [F-1•ROLL] or [F-2•SET],
rotate the main dial to select the desired memory
channel.
• [M-CH] (or [BANK]) control and direct keypad selection
can be used.
r Push and hold [F-3•SELECT] for 1 sec. to display
the memory-select window.
t Rotate the main dial to select the desired select
memory channel group.
★1 to ★9 are selectable
•
y Push [F-3•SELECT] to set the select setting ON.
• Push [F-3•SELECT] again to select the select setting
OFF.
u Repeat steps e to y to program another memory
channel as a select memory channel, if desired.
• If you want to set a same select channel group, skip
r and t
steps
i Push [EXIT/SET] to exit the memory list screen.
q Push [EXIT/SET] several times to close a multifunc-
tion screen, if necessary.
w Push [F-4•MEMORY] to select memory list screen.
e Push and hold [F-3•SELECT] for 1 sec. to display
memory-select window.
r Rotate the main dial to select the desired select
memory channel group to be erased.
t Push and hold [F-2• ALL CLR] for 1 sec. to clear all
select scan settings.
y Push [EXIT/SET] to exit the memory list screen.
8-12
.
.