Configure Optional Module - Intel Express 530T User Manual

C H A P T E R
LOCATION
Main Menu
Configure Stack
Optional Module...
NOTE
This screen is for Module A's
settings; the Matrix Module is
not configurable.
This screen also allows you to
configure the Module A ports
for any 535T switches in the
stack.
1000SX and 1000LX modules
connect at 1000Mbps, full-
duplex only.
58
®
5 Intel Express 530T Switch Users Guide

Configure Optional Module

Description
Select switch: Press the z to select a switch.
Module A: Displays the type of module installed.
State: Press the z to toggle the field and disable or enable ports.
Speed/Duplex: Press the z to toggle the field's options and
change the speed and duplex of the port. You can set the port to auto-
negotiate speed or force to 100Mbps at half- or full-duplex (535T
modules only).
Flow control: Press the z to enable or disable flow control.
Priority: Press the z to change the settings. The <Frame> setting
reads the packet's 802.1 priority tag and handles it accordingly. The
<Low> or <High > settings force the packet into one of two priority
queues. Forcing a packet into a queue does not retag the packet.
Link: Indicates the port's current link status:
• --: Indicates no device link or port is disabled.
• 10M/100M/1000M: The port's speed, either 10Mbps, 100Mbps,
or 1000Mbps (535T modules only; 530T modules are 1000Mbps
only).
• Full/Half: A device is connected at full- or half-duplex.
• IEEE/BackP: The type of flow control, either IEEE PAUSE
frames or backpressure.
• Partitioned: Port was disabled due to a partition error.
• Source mirror/Target mirror: The port being mirrored and
where the data is being sent.