Regulatory Information; Warnings - Intel Express 530T User Manual

Table of Contents

Advertisement

A P P E N D I X Technical Information

Regulatory Information

FCC Part 15 Compliance Statement
This product has been tested and found to comply with the limits
for a Class A digital device pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment.
This product generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning this equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Change the direction of the radio or TV antenna.
To the extent possible, relocate the radio, TV, or other
receiver away from the product.
Plug the product into a different electrical outlet so that
the product and the receiver are on different branch
circuits.
If these suggestions don't help, consult your dealer or an
experienced radio/TV repair technician for more suggestions.
NOTE This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that
may cause undesired operation.
CAUTION If you make any modification to the equipment not
expressly approved by Intel, you could void your authority to
operate the equipment.
Canada Compliance Statement (Industry Canada)
Cet appareil numérique respecte les limites bruits radioélectriques
applicables aux appareils numériques de Classe A prescrites dans
la norme sur le matériel brouilleur: "Appareils Numériques",
NMB-003 édictée par le Ministre Canadien des Communications.
This digital apparatus does not exceed the Class A limits for radio
noise emissions from digital apparatus set out in the
interference-causing equipment standard entitled: "Digital
Apparatus," ICES-003 of the Canadian Department of
Communications.
Manufacturer Declaration
This certifies that the Intel
Express 530T Switch complies with the EU
®
Directive 89/336/EEC, using the EMC standards EN55022 (Class A)
and EN55024. This product also meets or exceeds EN 60950 (safety)
requirements. These products have been tested and verified to meet
CISPR 22 Class A requirements.
Australia Statement
Taiwan Class A EMI Statement
VCCI Statement
Class A ITE
This is a Class A product based on the standard of the Voluntary
Control Council for Interference by Information Technology
Equipment (VCCI). If this equipment is used in a domestic
environment, radio disturbance may arise. When such trouble
occurs, the user may be required to take corrective actions.

Warnings

WARNING
This is a Class A product. In a domestic environment this product
may cause radio interference in which case the user may be
required to take adequate measures.
Internal access to Intel
Express 530T Switch intended only for
®
qualified service personnel. Do not remove any covers.
WARNING
The system is designed to operate in a typical office environment.
Choose a site that is:
Clean and free of airborne particles (other than normal
room dust).
Well ventilated and away from sources of heat including
direct sunlight.
Away from sources of vibration or physical shock.
Isolated from strong electromagnetic fields produced by
electrical devices.
In regions that are susceptible to electrical storms, we
recommend you plug your system into a surge
suppressor and disconnect telecommunication lines to
your modem during an electrical storm.
Provided with a properly grounded wall outlet.
Do not attempt to modify or use the supplied AC power cord if it
is not the exact type required.
Ensure that the system is disconnected from its power source and
from all telecommunications links, networks, or modems lines
whenever the chassis cover is to be removed. Do not operate the
system with the cover removed.
121

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents