Netbios Port Monitor For Windows 95/98, Nt4.0 - Brother NC-series User Manual

USER'S GUIDE

NetBIOS Port Monitor for Windows 95/98, NT4.0

This software requires the TCP/IP or NetBEUI transport protocols to be
installed on your Windows 95/98, NT4.0 computer. To install those
protocols refer to your Windows 95/98, NT4.0 documentation.
If you are using the TCP/IP protocol, the proper IP address should be
defined on both the Brother print server and your client PC.
Installing the Brother NetBIOS Port Monitor
1. Insert the backup diskette into the PC. From the Windows 95/98/NT4.0
2. Push the Next button in response to the Welcome message.
3. Select Brother Peer-to-Peer Print (NetBIOS) installation
4. Select the desired directory to install the Brother Network Direct Print
Note
If you are using the new NetBIOS feature, you have to use version 1.0 or
later of the Brother NetBIOS Port monitor with the Firmware version
3.59 or later in you Brother print server. Version 1.0 or later of the
Brother NetBIOS Port Monitor is not compatible with previous versions
of print Brother server firmware.
Note
Make a backup of the Brother Network Print Software disk and use this
backup for the installation process. Store the original diskette in a safe
place.
Note
If you already installed a previous version of this Port Monitor
software. You must remove it before you install the later version.
Start button, select Run. Then enter A:SETUP and press Enter to start
the Brother Network Direct Print installation program.
Note
Previous versions of this software would display "Brother Peer to Peer
Print (NetBEUI) installation".
files and push Next.
5–4