Appendix; Command Summary; General Commands - Brother NC-series User Manual

APPENDIX

Appendix A

Command Summary

General Commands

Although it is not normally necessary to change Brother print server default
parameters, you can change the configuration using any of the following
methods:
• Brother BRAdmin32 utility for Windows 95/98 and NT 4.0
• Brother BRAdmin Netware utility for Windows 3.1
• HTTP (using a web browser)
• TELNET
• Brother BRCONFIG NetWare Utility
• DEC NCP or NCL Utility
BRAdmin32 The Brother BRAdmin32 utility can use the TCP/IP or
BRAdmin
HTTP
TELNET
IPX/SPX protocol. This utility allows you to graphically
manage aspects of the network and printer. It runs on
Windows 95/98 and Windows NT 4.0
The Brother BRAdmin Netware utility requires a Novell
Netware file server to operate. This utility allows you to
graphically manage aspects of the network and printer. To
use BRAdmin, Novell Network is necessary and have to
attach a NetWare server. As for installation, refer to Chapter
1-3.
Use your favorite web browser to connect to the Brother print
server. This will allow you to configure print server
parameters. You must ensure that the print server has a valid
IP address. Once you have done this type
http://ip_address/ in your web browser. If you can
not connect to the print server check your web browser is
configured correctly (check your proxy settings to ensure that
your web browser can connect to the printer on your internal
network).
To connect to the print server using TELNET on UNIX,
Windows NT, or most other TCP/IP systems, type: TELNET
ipaddress at the UNIX system prompt, where ipaddress is
the IP address of the print server. When you are connected,
push RETURN or ENTER to get the "#" prompt, enter the
password "access" (the password will not appear on the
screen), and type anything in response to the Enter
Username> prompt. When you see the Local> prompt,
you are ready to enter commands.
A-1
APPENDIX