Brother NC-series User Manual page 125

APPENDIX
<For NC-2010p only>
SET PORT P1 ACKH [EN|DIS]
Enables or disable ACKH on parallel port
SET PORT P1 BIDir [EN|DIS]
Enable or disable bi-directional mode on parallel port
SET PORT P1 DVID [EN|DIS]
Enable or disable 1284 device ID queries on parallel port
SET PORT P1 ECP [EN|DIS]
Enable or disable 1284 ECP mode on parallel port
SET PORT P1 FSTB [EN|DIS]
Enable or disable fast strobe mode on parallel port
SET PORT P1 NBUF [EN|DIS]
Enable or disable no buffering on parallel port
<For NC-2010h and NC-2100h only>
SET PORT S1 CHaracter [7|8]
Set bits per character on serial port
SET PORT S1 Flow [NO|XO|CT|DS]
Set serial port flow control to NONE, XON/XOFF, CTS, or DSR
SET PORT S1 PArity <parity>
Set serial port parity to NONE, EVEN, ODD, MARK, or SPACE
SET PORT S1 SIgnal [EN|DS]
Enables/disables DTR signal check on serial port
SET PORT S1 SPeed <baudrate>
Sets serial port baud rate from 300-57600 bits per second
SET PORT S1 STop [1|2]
Sets serial port stop bits per character
SET SERVIce <servicename> POrt <portname>
Change service port (<portname> is P1 for printer BIO port and S1 is for
NC-2010h/NC-2100h serial port)
SHow SERVEr QUeue
Shows print server internal queue and printer front panel
<For NC-2100h only>
SET ENET MODE [AUTO|10BAse|100BAse]
Set Ethernet speed
SHow ENET MODE
Set Ethernet mode
A-5