Brother NC-series User Manual page 102

1. Make a backup copy of Brother Network Print Software disk, and use
this backup for the installation process. Store the original diskette in a
safe place.
2. Insert the backup installation diskette into the PC. From the Windows
95/98/NT4.0 Start button, select Run. Then enter A:\SETUP and
press Enter to start the BIP installation program.
3. Push the Next button in response to the Welcome message.
4. Select the Brother Internet Print button.
5. Select the desired directory to install the BIP files and then push Next.
The installation program will create the directory for you if it does not
already exist.
6. Select either WINSOCK (the default) or MAPI as the mail transport
protocol and press Next. (Windows 95/98 only) Most mail programs,
include Microsoft Exchange which is included with Windows 95/98,
use MAPI. The installation program will then begin installing the
files.
7. You will then be asked for a port name. Enter the name of the port.
The port name must begin with the BIP and end with a number, for
example, BIP1.
8. You will then see a message about Partial E-mail Print. Partial E-mail
Print is the ability of the Brother Internet Print software to break down
E-mail Print jobs into smaller sections to prevent a mail file size
limitation problem for mail server. This feature is only available on
Brother print servers with version 3.47 or later.
9. Press OK to continue.
10. You will then be asked to enter the port settings for the remote print
server:
Enter any unique legal Internet E-mail address for the remote print
server (for example emailprinter@xyz.com). Note that Internet E-
mail addresses cannot have spaces in them.
If you are using WINSOCK, enter your E-mail address and the IP
address of your SMTP E-mail server (consult your network
administrator if you do not know this address). Also specify if you are
going to use the Partial E-mail Print option and Notification type.
CHAPTER 11 BROTHER INTERNET PRINT (BIP)
11-3