Reloading The Print Server Firmware; Downloading From Bradmin32 On The Windows 95/98/Nt4 - Brother NC-series User Manual

Appendix C

Reloading the Print Server Firmware

The firmware on the print server is stored in flash memory. This means that
you can upgrade the firmware by downloading the appropriate update file.
Update files are available from Internet access (www.brother.com).
Note
We recommend that you factory reset the print server if you upgrade to a
later version of software. Instructions on how to perform a factory reset
can be found in the quick setup guide that accompanies the print server.
Downloading from BRAdmin32 on the Windows
95/98/NT4
The BRAdmin32 utility can be used to easily re-program your Brother print
server.
Start the BRAdmin32 software.
Highlight the appropriate print server. Then press CTRL+L. You can select
more than one print server by pressing CTRL+<select> or SHIFT+<select>
on each additional print server.
There are three possible ways of sending the new software version to the
print server. For which ever method you select, you must enter a password
for the print server. The default password for the print server is "access".
A-13
APPENDIX