Changing The Domain Name Using Telnet Or Brconfig - Brother NC-series User Manual

Changing the domain name using TELNET or BRCONFIG

If you are unable to use a BRAdmin utility or a web browser, you can use
TELNET or the BRCONFIG Remote console program (BRCONFIG
requires the IPX/SPX protocol to be installed on your PC).
When you are connected to the print server, enter the default password
"access" in response to the "#" prompt. Type in anything in response to the
"Enter Username>" prompt, you will then be at the "Local>" prompt.
Now enter the command:
SET NETBIOS DOMAIN domainname
EXIT
Note
If you are using SMB on NetBEUI with old firmware and the old
NetBEUI port Monitor,
Use: SET NETBEUI DOMAIN domainname
where domainname is the name of the domain or workgroup that you are
on. If you are not sure what your domain name or workgroup name is look
in the Identification tab in your Windows 95/98/NT 4.0 network applet.
CHAPTER 5 NetBIOS CONFIGURATION (NetBEUI and TCP/IP)
5–3