Table of Contents
Advertisement
USER'S GUIDE
2. Make sure that the print server is installed and running with
Because access to the E-mail server on most networks is usually
restricted, you may need to have your network administrator
check the configuration and add the mail account.
Using BRAdmin or BRAdmin32 to Configure the Print Server
To use BRAdmin, you must be running either NetWare or
Banyan VINES client software, and the PC must be on the same
network as the Brother remote print server. If you use the
BrAdmin32 utility, you can configure the Brother print server
using the TCP/IP protocol, or the IPX protocol.
The steps required to configure the print server to receive print
jobs from a Windows 95/98/NT4.0. PC running the BIP
software is as follows:
1. If you have not already done so, install the appropriate
2. Start the BRAdmin program.
3. Select the node name of the desired Brother print server
4. Click on the Internet tab.
5. Enter the IP address of the POP3 server (consult your
6. Enter the mailbox name for the remote Brother print server.
TCP/IP enabled and has a valid IP address assigned to it.
Note
Skip this section if you wish to use the print server console or
Web Browser to configure the print server.
BRAdmin utility on the PC that will be used to configure
the print server. This is done by selecting Run from the
Windows 3.1x program manager or by pressing the
Windows 95/98/NT4.0 Start button and selecting Run. In
both cases, enter A:SETUP as the program name, and
follow the instructions of the installation program.
from the list and double clicking on it. (the default node
names are BRO_xxxxxx_P1 or BRO_xxxxxx, where "xxxxxx" is
the last six digits of the Ethernet address). You will be
prompted for a password, the default password is "access".
network administrator if you do not know this address).
Usually this will be the first part of the E-mail (for example,
if the E-mail address of the remote print server is
emailprinter@xyz, then the mailbox name would be
emailprinter).
11-6
Advertisement
Table of Contents
Troubleshooting
