Brother NC-series User Manual page 107

USER'S GUIDE
1. When you get the "Local>" prompt after connecting to the
2. Enter the command:
3. The print server is set by default to poll the POP3 server
4. Type EXIT to exit the console and save the changes. You
console, enter the command:
SET POP3 ADDRESS
where ipaddress is the IP address of your POP3 server
(consult with your network administrator if you do not
know this address).
SET POP3 NAME
SET POP3 PASSWORD
where mailboxname is the name of the remote print server
mailbox and emailpassword is the password associated with
this mailbox. Usually the mailbox name is the same as the
first part of the E-mail address that you defined previously
(for example, if the E-mail address is
emailprinter@xyz.com, then the mailbox name is
emailprinter).
every 30 seconds. If you wish to change this value, enter the
command:
SET POP3 POLLING
where rate is the polling rate in seconds.
have now completed configuring the remote print server.
ipaddress
mailboxname
emailpassword
rate
11-8