Testing The Print Queue - Brother NC-series User Manual

For example, to set up remote "Printer 3" for an Brother printer with
the print server BRO_00C3E4_P1 using the PSERVER NLM called
BROTHER1PS, you would type:
SET NETWARE NPRINTER BROTHER1PS 3 ON BRO_00C3E4_P1
SET NETWARE RESCAN
EXIT
You can also enter the remote printer name using your web browser
by connecting to the Brother print server using the TCP/IP protocol
and selecting the Netware protocol configuration.
Note
The same services assigned by Netware print server name cannot be used
for both queue server mode and remote printer mode.
You must now unload the PSERVER NLM from your NetWare file
server console and then reload it in order for the changes to take effect.

Testing the Print Queue

Test the queue by using the NetWare DOS nprint command:
C:> nprint c:\autoexec.bat q=queuename
where queuename is one of the print queues you created earlier in this
chapter. The file will be spooled to the print server for printing and should
print on the printer within a short period of time. If it does not, double
check your configuration, and if necessary,
Troubleshooting information.
CHAPTER 1 NOVELL NETWARE CONFIGURATION
refer to Chapter 12 for
1-16