Brother Internet Print Using Bradmin To Configure The Print Server - Brother HL-1470N Network User's Manual

Brother Internet Print
Using BRAdmin to Configure the Print
Server
Skip this section if you wish to use the print server remote console or Web Browser
to configure the print server.
Using the BRAdmin application, you can configure the Brother print server using the
TCP/IP protocol, or the IPX protocol.
The steps required to configure the print server to receive print jobs from a Windows
95/98//Me/NT4.0. PC running the BIP software is as follows:
1. Start BRAdmin.
2. Select the node name of the desired Brother print server from the list and
double clicking on it. (the default node name is usually BRN_xxxxxx,
where "xxxxxx" is the last six digits of the Ethernet address (MAC
address)). You will be prompted for a password, the default password is
"access".
You can find the node name and MAC address by printing out the printer
configuration page. Refer to the Quick Setup Guide for information on how to print
the configuration page on your print server.
3. Click on the Internet tab.
4. Enter the IP address of the POP3 server (consult your network administrator
if you do not know this address).
5. Enter the mailbox name for the remote Brother print server. Usually this will
be the first part of the E-mail address (for example, if the E-mail address of
the print server is emailprinter@xyz, then the mailbox name would be
emailprinter).
6. Enter the password for the mailbox, if any.
7. The print server is configured by default to poll the POP3 server every 30
seconds. You may change this value, if desired.
8. If you have enabled notification, enter the IP address of your SMTP server
(consult your network administrator if you do not know this address).
9. Press the OK button and save the changes. Now exit the BRAdmin
application. You have now configured the print server to receive print jobs.
CHAPTER 5 BIP INTERNET PRINTING INSTALLATION
5-4