Sending Documents - Olivetti d-Copia 23 Operation Manual

Section 1 Basic Use of this Fax

Sending Documents

The following contains explanations on the standard method for transmitting
documents. Carefully read all the notes regarding acceptable documents, etc.,
to ensure correct operation.
Switching to the Fax Operation mode
1 1
Press the FAX key to switch to the Fax Operation mode.
* When the lamp in the FAX key is lit, the machine is in the
Fax Operation mode.
Selecting the transmission mode
2 2
Select the desired transmission mode.
* There are two transmission modes available in this fax:
Memory Transmission and Direct Feed Transmission.
Memory Transmission is the default setting in this fax and,
in this case, the MEMORY TX. indicator will be lit.
* If the MEMORY TX. indicator is NOT lit, the fax is in the
Direct Feed Transmission mode.
1-18
* Check the message display to make sure that the operation panel
is in the initial mode for fax operation. If the operation panel is not
in the initial mode, press the Reset key.
Set original
* To switch between the Memory Transmission and Direct Feed
Transmission modes, raise both cover plates and press the
MEMORY TX. key.
01-DEC-1999 12:00