Setting The Date And Time - Olivetti d-Copia 23 Operation Manual

Section 1 Basic Use of this Fax

(3) Setting the Date and Time

Set the date and the time that will appear in the message display
here. BE SURE that the date and time that you set here are correct
since they will serve as a basis for all communications that use the
timer.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
Checking the initial mode display
1 1
Check the message display to make sure that the operation
panel is in the initial mode for fax operation.
(Refer to "(2) Initial Mode", page 1-12.)
* If the fax is not in the Fax Operation mode, press the FAX
key to light the lamp in that key.
Set original
Entering the "Program" mode
2 2
Raise both cover plates that are located over the one-touch
keys and press the REGISTER key.
The "Program" menu will appear in the message display.
Program:
End
Program abbreviated dial
Program one-touch key
Scroll through the menu with the cursor up or the cursor down
3 3
key and select "Program fax parameter".
Program:
Subaddress box register
Program encryption code
Program fax parameter
1-8
30-NOV-1999 10:00
Press the Enter key. The "Program fax parameter" menu will
4 4
appear in the message display.
Program fax parameter:
End
:
Own name
Scroll through the menu with the cursor up or the cursor down
5 5
key and select "Date and time".
Program fax parameter:
Remote switch :55
Remote test ID:0000
Date and time :10:00
Press the Enter key.
6 6
Date and time:30-11-1999 10:00
Set date and time
Entering the date and time
7 7
Use the keypad to enter the present date and time.
* If you want to advance the cursor to the next space,
simply press the cursor right key.
* If you want to clear the currently displayed date and time
from the message display and enter it once again from the
beginning, simply press the Stop/Clear key.
Date and time:01-12-1999 12:00
Set date and time
Press the Enter key.
8 8
The setting of the time and date is complete.
* If you are finished making settings, press the Reset key.
The operation panel will return to the initial mode settings.
Program fax parameter:
Remote switch :55
Remote test ID:0000
Date and time :12:00
: