Table of Contents
Advertisement
Prestige 861H Series User's Guide
Figure 17 Internet Access Wizard Setup: ISP Parameters
The following table describes the fields in this screen.
Table 10 Internet Access Wizard Setup: ISP Parameters
LABEL
Mode
Encapsulation
Multiplex
Virtual Circuit
ID
VPI
VCI
Next
If you select PPPoA encapsulation in the previous screen, proceed to table 4.16. If you select
RFC 1483 encapsulation in the previous screen, verify the settings in the screen shown next.
Click Save Settings to save the configuration and test the connection to the computer(s)
connected to the LAN ports.
57
DESCRIPTION
From the Mode drop-down list box, select Bridge.
Select the encapsulation type your ISP uses from the Encapsulation drop-down list
box. Choices vary depending on what you select in the Mode field.
Select either PPPoA or RFC 1483.
The multiplexing method used by your ISP is LLC-based.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit.
Refer to the appendix for more information.
Enter the VPI assigned to you. This field may already be configured.
Enter the VCI assigned to you. This field may already be configured.
Click this button to go to the next wizard screen. The next wizard screen you see
depends on what protocol you chose above. Click on the protocol link to see the next
wizard screen for that protocol.
Chapter 3 Wizard Setup for Internet Access
Advertisement
Table of Contents
Troubleshooting
