Figure 17 Internet Access Wizard Setup: Isp Parameters; Table 6 Internet Access Wizard Setup: Isp Parameters - ZyXEL Communications P-2602HWLNI User Manual

Figure 17 Internet Access Wizard Setup: ISP Parameters

The following table describes the fields in this screen.

Table 6 Internet Access Wizard Setup: ISP Parameters

LABEL
Mode
Encapsulation
Multiplexing
Virtual Circuit
ID
VPI
VCI
Back
Next
Exit
2 The next wizard screen varies depending on what mode and encapsulation type you use.
All screens shown are with routing mode. Configure the fields and click Next to
continue. See
P-2602HWLNI User's Guide
DESCRIPTION
From the Mode drop-down list box, select Routing (default) if your ISP allows
multiple computers to share an Internet account. Otherwise select Bridge.
Select the encapsulation type your ISP uses from the Encapsulation drop-down list
box. Choices vary depending on what you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or
PPPoE.
Select the multiplexing method used by your ISP from the Multiplex drop-down list
box either VC-based or LLC-based.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit.
Refer to the appendix for more information.
Enter the VPI assigned to you. This field may already be configured.
Enter the VCI assigned to you. This field may already be configured.
Click Back to go back to the previous screen.
Click Next to continue to the next wizard screen. The next wizard screen you see
depends on what protocol you chose above.
Click Exit to close the wizard screen without saving your changes.
Section 3.3 on page 71
Chapter 3 Internet and Wireless Setup Wizard
for wireless connection wizard setup
67