Table of Contents
Advertisement
Figure 110 NAT Example 2
In this case, you do exactly as above (use the convenient pre-configured SUA Only set) and
also go to menu 15.2 to specify the Inside Server behind the NAT as shown in the next figure.
Figure 111 Menu 15.2.1 Specifying an Inside Server
20.5.3 Example 3: Multiple Public IP Addresses With Inside Servers
In this example, there are 3 IGAs from our ISP. There are many departments but two have
their own FTP server. All departments share the same router. The example will reserve one
IGA for each department with an FTP server and all departments use the other IGA. Map the
FTP servers to the first two IGAs and the other LAN traffic to the remaining IGA. Map the
third IGA to an inside web server and mail server. Four rules need to be configured, two bi-
directional and two unidirectional as follows.
Map the first IGA to the first inside FTP server for FTP traffic in both directions (1 : 1
mapping, giving both local and global IP addresses).
Chapter 20 Network Address Translation (NAT)
Menu 15.2 - NAT Server Setup
Rule
Start Port No.
---------------------------------------------------
1.
Default
2.
0
3.
0
4.
0
5.
0
6.
0
7.
0
8.
0
9.
0
10.
0
11.
0
12.
0
Press ENTER to Confirm or ESC to Cancel:
Prestige 861H Series User's Guide
End Port No.
IP Address
Default
192.168.1.10
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
0
0.0.0.0
182
Advertisement
Table of Contents
Troubleshooting
