Table of Contents
Advertisement
Prestige 861H Series User's Guide
Figure 26 WAN Remote Nodes
The following table describes the fields in this screen.
Table 13 WAN Remote Nodes
LABEL
Num
Name
Active
Encap
VPI
VCI
QoS
PCR
CDVT
SCR
77
DESCRIPTION
Select a remote node number to display the WAN Setup configuration screen.
This field displays the name of the remote node, e.g., MDWARE. This
information is for identification purposes only.
This field displays the status of a remote node
This field displays the method of encapsulation used by your ISP. Choices vary
depending on the operating mode of each remote node.
If the operating mode is set as Bridge, this field displays either PPPoA or RFC
1483.
If the operating mode is set as Routing, this field displays PPPoA, RFC 1483,
ENET ENCAP or PPPoE.
This field displays the VPI assigned to you. The valid range for the VPI is 0 to
255.
This field displays the VCI assigned to you. The valid range for the VCI is 32 to
65535 (0 to 31 is reserved for local management of ATM traffic).
This field displays the ATM QoS Type.
CBR (Constant Bit Rate) specifies a fixed (always-on) bandwidth for voice or
data traffic.
UBR (Unspecified Bit Rate) is used for applications that are non-time sensitive,
such as e-mail.
VBR-RT (Real Time Variable Bit Rate) or VBR-nRT (non Real Time Variable Bit
Rate) is used with bursty traffic and bandwidth sharing with other applications.
This field displays the Peak Cell Rate (PCR). This is the maximum rate at which
the sender can send cells.
This field displays the accepted tolerance of the difference between a cell's
transfer delay and the expected transfer delay.
This field displays the Sustain Cell Rate (SCR). The SCR sets the average cell
rate (long-term) that can be transmitted.
Chapter 5 WAN Setup
Advertisement
Table of Contents
Troubleshooting
