Table of Contents
Advertisement
Prestige 861H Series User's Guide
Figure 9 Internet Access Wizard Setup: ISP Parameters
The following table describes the fields in this screen.
Table 4 Internet Access Wizard Setup: ISP Parameters
LABEL
Mode
Encapsulation
Multiplex
Virtual Circuit
ID
VPI
VCI
Next
3.1.1.1 Internet Access Wizard Setup : Routing
The ISP Parameters for Internet Access screen varies depending on what mode and
encapsulation type you use. Configure the fields and click Next to continue.
49
DESCRIPTION
From the Mode drop-down list box, select Routing if your ISP allows multiple
computers to share an Internet account. Otherwise select Bridge and proceed to
section 3.1.1.2.
Select the encapsulation type your ISP uses from the Encapsulation drop-down list
box.
Select PPPoA, RFC 1483, ENET ENCAP or PPPoE.
The multiplexing method used by your ISP is LLC-based.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit.
Refer to the appendix for more information.
Enter the VPI assigned to you. This field may already be configured.
Enter the VCI assigned to you. This field may already be configured.
Click this button to go to the next wizard screen. The next wizard screen you see
depends on what protocol you chose above. Click on the protocol link to see the next
wizard screen for that protocol.
Chapter 3 Wizard Setup for Internet Access
Advertisement
Table of Contents
Troubleshooting
