Table of Contents
Advertisement
Figure 81 Menu 4 Internet Access Setup
The following table contains instructions on how to configure your Prestige for Internet
access.
Menu 4 Internet Access Setup
Table 44
FIELD
ISP's Name
Encapsulation
Multiplexing
VPI #
VCI #
Service Name
My Login
My Password
Network Address
Translation
Address Mapping
Set
IP Address
Assignment
IP Address
Chapter 16 Internet Access
Menu 4 - Internet Access Setup
ISP's Name= MyISP
Encapsulation= ENET ENCAP
Multiplexing= LLC-based
VPI #= 8
VCI #= 35
Service Name= N/A
My Login= N/A
My Password= N/A
NAT= Full Feature
Address Mapping Set= 1
IP Address Assignment= Dynamic
IP Address= N/A
ENET ENCAP Gateway= N/A
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Enter the name of your Internet Service Provider (ISP). This information is for
identification purposes only.
SPACE BAR
Press [
] to select the method of encapsulation used by your ISP.
Choices are PPPoE, PPPoA, RFC 1483 or ENET ENCAP.
This field displays the method of multiplexing used by your ISP.
Enter the Virtual Path Identifier (VPI) assigned to you.
Enter the Virtual Channel Identifier (VCI) assigned to you.
Type a Service Name for PPPoE encapsulation only.
Configure the My Login and My Password fields for PPPoA and PPPoE
encapsulation only. Enter the login name that your ISP gives you. If you are using
PPPoE encapsulation, then this field must be of the form user@domain where
domain identifies your PPPoE service name.
Enter the password associated with the login name above.
SPACE BAR
Press [
] to select None, SUA Only or Full Feature. Please see the
NAT chapter for more details on the SUA (Single User Account) feature.
Type the numbers of mapping sets (1-8) to use with NAT.
SPACE BAR
Press [
] to select Static or Dynamic address assignment.
Enter the IP address supplied by your ISP if applicable.
Prestige 861H Series User's Guide
152
Advertisement
Table of Contents
Troubleshooting
