Chapter 3 Wizard Setup for Internet Access
Figure 11 Wizard: Welcome
3 Type the Internet access information given to you by your ISP exactly in the wizard
screen. If not given, leave the fields set to the default.
Figure 12 Internet Access Wizard Setup: ISP Parameters
The following table describes the fields in this screen.
Table 5 Internet Access Wizard Setup: ISP Parameters
LABEL
Mode
Encapsulation
Multiplexing
Virtual Circuit
ID
48
DESCRIPTION
From the Mode drop-down list box, select Routing (default) if your ISP allows
multiple computers to share an Internet account. Otherwise select Bridge.
Select the encapsulation type your ISP uses from the Encapsulation drop-down list
box. Choices vary depending on what you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or
PPPoE.
Select the multiplexing method used by your ISP from the Multiplex drop-down list
box either VC-based or LLC-based.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit.
Refer to the appendix for more information.
P-791R v2 User's Guide