Table of Contents
Advertisement
Prestige 861H Series User's Guide
Figure 161 Menu 25.1.1 IP Routing Policy
Policy Set Name= test
Active= No
Criteria:
IP Protocol
Type of Service= Don't Care
Precedence
Source:
addr start= 0.0.0.0
port start= N/A
Destination:
addr start= 0.0.0.0
port start= N/A
Action= Matched
Gateway addr
Type of Service= No Change
Precedence
The following table describes the fields in this menu.
Table 73 Menu 25.1.1 IP Routing Policy
FIELD
Policy Set Name
Active
Criteria
IP Protocol
Type of Service
Precedence
Packet Length
Len Comp
Source:
addr start / end
port start / end
Destination:
addr start / end
port start / end
Action
239
Menu 25.1.1 - IP Routing Policy
= 0
= Don't Care
= 0.0.0.0
= No Change
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
This is the policy set name assigned in Menu 25 – IP Routing Policy Setup.
Press [SPACE BAR] and then [ENTER] to select Yes to activate or No to
deactivate the policy. Inactive policies are displayed with a minus sign "-" in SMT
menu 25.
IP layer 4 protocol, for example, UDP, TCP, ICMP, etc.
Prioritize incoming network traffic by choosing from Don't Care, Normal, Min
Delay, Max Thruput, Min Cost or Max Reliable.
Precedence value of the incoming packet. Press [SPACE BAR] and then
[ENTER] to select a value from 0 to 7 or Don't Care.
Type the length of incoming packets (in bytes). The operators in the Len Comp
(next field) apply to packets of this length.
Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal,
Less, Greater, Less or Equal or Greater or Equal.
Source IP address range from start to end.
Source port number range from start to end; applicable only for TCP/UDP.
Destination IP address range from start to end.
Destination port number range from start to end; applicable only for TCP/UDP.
Specifies whether action should be taken on criteria Matched or Not Matched.
Packet length= 0
Len Comp= N/A
end= N/A
end= N/A
end= N/A
end= N/A
Log= No
Chapter 27 IP Policy Routing
Advertisement
Table of Contents
Troubleshooting
