Ethernet, Ip And Wan Commands; Ethernet Commands; Ip Commands; Table 78 Ether Command Summary - ZyXEL Communications P-861H-G2 User Manual

This chapter shows you information about the LAN and WAN interfaces and IP address
details and gives a summary of commands available.

31.1 Ethernet Commands

The following chart lists and describes the ether commands. Each of these commands must be
preceded by ether when you use them. For example, type
information on the LAN configuration.
ether Command Summary
Table 78
MODULE COMMAND SUB-COMMAND
ether version
config
driver

31.2 IP Commands

The following chart lists and describes the ip commands. Each of these commands must be
preceded by ip when you use them. For example, type ip address to display information on the
host IP address.
These are the commonly used commands that belong to the ip group of commands.
IP Command Summary
Table 79
MODULE COMMAND
ip address
alias
Chapter 31 Ethernet, IP and WAN Commands
Ethernet, IP and WAN
ARGUMENTS DESCRIPTION
cnt disp <name>
ioctl <ch_name>
<command>
[arguments]
status <ch_name>
SUB-COMMAND ARGUMENTS
[addr]
<iface>
Prestige 861H Series User's Guide
C
H A P T E R
Commands
ether config
Displays the Ethernet device type.
Displays information about the configuration
block.
Displays the Ethernet driver counters.
This command cannot be used currently.
Shows the LAN status.
DESCRIPTION
Displays the host IP address.
Sets an alias for the specified interface.
31
to display
258