Ppds Emulation; Download Emuls; Demo Mode; Factory Defaults - Lexmark C925 Service Manual

5041-030

PPDS Emulation

This appears only if the PPDS interpreter is available.

Download Emuls

Warning: This setting should not be changed without specific instructions from the next level of support.
This setting temporarily disables downloaded emulators for troubleshooting purposes. All downloaded
emulators are re-enabled automatically after two PORs.

Demo Mode

This printer supports a demo mode that is usually used in retail environments to illustrate the features of the
printer. The printer features are illustrated by demonstration files stored in the RIP firmware, flash option, or disk
option. This mode is deactivated by default.

Factory Defaults

The customer can restore either the network settings or the base printer settings to their factory default values.
When Restore Base is selected, non-critical base printer NVRAM settings are restored. When Restore STD Net
is selected, all network NVRAM settings are restored to their factory default settings. This option is available
only on models with an integrated network adapter. When Restore LES is selected, all non-standard
applications are removed and all framework and standard application settings are reset to factory default
settings.

Energy Conserve

When Energy Conserve is on, the customer does not have access to disable the Sleep Mode function. When
Energy Conserve is off, Disable appears as an additional menu item in the Sleep Mode menu. This setting only
affects the values that are displayed in the Sleep Mode menu.

Auto Align Adj

The printer automatically runs a Toner Patch Sensing (TPS) diagnostic after certain key events. Depending on
the type of event, the results of the diagnostics can trigger either a color adjust calibration or an alignment
calibration. If necessary, the printer will automatically adjust the alignment.
If Auto Align Adj is set to Off, then the diagnostic still runs, but the printer will not use the resulting data to
automatically adjust alignment. This could eventually lead to the user having to adjust alignment manually.
Therefore, Auto Align Adj should not be set to Off during normal printer usage.
3-10
Service Manual
Previous
Next
Go Back