5041-030
Registration roll removal
Note: This removal applies to both sets of registration rolls. To remove the lower roll, you will need to separate
the MFP feed unit from the main feed unit. See
page 4-94
for instructions.
1.
Remove the static discharge brush plate (top feeder only).
2.
Remove the static discharge brush (top feeder only).
3.
Remove the registration roll gears (A).
4.
Remove the e-clips (B) securing the registration rolls to the paperfeed unit
5.
Remove the bushings (C) holding the registration roll to the paperfeed unit.
6.
Remove the registration springs (D).
7.
Slide the registration rolls out of the paperfeed unit.
4-106
Service Manual
"Separating the MPF tray and main tray paperfeed units" on
Previous
Next
Go Back